DAASCNC has a vertical, horizontal, oil pressure-driven, servo-driven full series of various kinds of spline rolling machines, with many years of manufacturing and service experience, in order to make users in the selection can distinguish good from bad, we will list all kinds of spline rolling machine-related information, so users can select the model rationally according to the demand of the target parts. Of course, all comparisons can only be made between horizontal machines and vertical machines, hydraulic machines, and servo machines of the same specification. Meanwhile, due to our limited experience, we hope that our peers can correct us where we are shallow.
1) The main machine has a large floor area, low center of gravity and good overall rigidity, good vibration absorption ability in the processing process, better processing ability and noise than the vertical machine, and better durability.
2)Daily loading, loading dies, and machine height adjustment are all in 1000mm, no need to climb the height operation, operation safety, and operation convenience is better. However, the difference between the smaller models and vertical models is not obvious ( Models smaller than 24 inches ).
3)Most horizontal machines are equipped with detachable steel guide rails for easy maintenance. No need to climb the height for maintenance (the total height of the machine generally does not exceed 1700mm).
4)Convenient transportation, easy Installation, and adjustment. Vertical )The vertical model covers a small area and is a good choice for users who are short of space; 2)When connecting the line, the span is relatively short, reducing the transmission cycle time.
1)The vertical model covers a small area and is a good choice for users who are short of space.
2)When connecting the line, the span is relatively short, reducing the transmission cycle time.
In the following cases, users are advised to choose horizontal models, in the opposite user’s case can choose the vertical model:
1) The effective spline length of the target part may exceed 80mm.
2) Target parts’ spline modulus may be greater than 1.27mm.
3) The diameter of the spline of the target part may exceed 40mm.
4) The spline modulus of the target part may change significantly.
5) The target parts may need models of 24 inches or more.
6) To cover a floor area of the request is not high or mind to climb the operation.
7) The operator is used to the horizontal model and the maintenance personnel are familiar with the horizontal model.